中文简体
English
Español
عربى
1. Pull out the pull rod so that the piston in the cylinder is close to the rear end cover, and then lock the pull rod.
2. Fill the cylinder with lubricating grease. When using the oil filler, thread the top of the oil storage cylinder into the thin screw of the oil filler, and use the oil filler to put lubricating grease into the oil storage cylinder. If you put lubricating grease directly into the cylinder by hand, first unscrew the front cover, put the clean lubricating grease into the oil storage cylinder by hand until the entire oil storage cylinder is filled, then screw on the front end cover to unlock the pull rod, And wipe the grease gun clean with cotton gauze.
LD-808 Two cylinder Industrial grade hand grease gun 600cc
3. Hold the oil storage tank with one hand and the hand pressure lever with the other hand, press the manual pressure lever back and forth to discharge the air in the cylinder, and stop pressing the manual pressure lever when lubricating grease appears at the oil nozzle.
4. Align the oil nozzle at the front end of the oil injection rod and press it tightly on the grease nozzle of the part that needs to be lubricated, press down the hand pressure lever close to the oil storage tank until it cannot be pressed down, and then lift the hand pressure lever to the original position , then press down and lift up, and reciprocate the manual pressure lever to slowly press the lubricating grease into the parts that need to be lubricated. After filling the lubricating grease, pull out the grease gun.
5. If the front end of the oiling rod of the grease gun is inconvenient to approach the oiling part that needs to be lubricated, a hose should be put on the oiling rod, and the buckle should be fastened to prevent leakage from the socket when the lubricating grease is squeezed. The other end of the hose is equipped with a mouth cover and an inner plug that match the thread of the grease nipple, and the inner plug is inserted into the grease nipple of the oil injection part, and then the mouth cover is tightened, and the lubricating grease can be filled to the oil injection site according to the above method.
